Project Overview:
The purpose of this project was to make a circuit that buzzes when two or more of the sensors were blocked by a piece of paper at one time. We had to keep the system buzzing until we hit a button to stop the buzzing.
- I did not use resistors when I made it because if I was to have to build the circuit it would add in other materials that are not needed for it to work.
- The purpose of the Combinational logic circuit is to make the buzzer go off when paper is blocked in two of the light sensors.
- We have a flip flop gate because if the flip flop has a jam or has it's clear button pressed it will not reset until another one is pressed.
- The LED goes off but the buzzer stays on because when the preset is not on anymore the flip flop will keep the output of 1 until the clear is set off.
Conclusion:
- This Project is different because we had to plug it into a device created for a specific application instead of using a breadboard like we have for all of the other projects we have done.